ZDX V6-3.7L (2010)
Shifter A/T: Testing and Inspection
Paddle Shifter Illumination Circuit Troubleshooting
Paddle Shifter Illumination Circuit Troubleshooting
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair
before doing repair or service.
1. Remove the driver's airbag See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Driver's Airbag
Replacement.
2. Disconnect the paddle shifter connector.
3. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and turn the combination light switch to the
SMALL (PARKING) position.
4. Measure the voltage between paddle shifter connector terminal No. 1 and body ground.
Is there battery voltage?
YES -
Go to step 8.
NO -
Go to step 5.
5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode, and turn the combination light switch to the
OFF position.
6. Check the No. 6 (7.5 A) fuse in the passenger's under-dash fuse/relay box.
Is the fuse OK?
YES -
Repair an open in the wire between paddle shifter connector terminal No. 1 and the passenger's under-dash fuse/relay box.
NO -
Go to step 7.
7. Check for continuity between paddle shifter connector terminal No. 1 and body ground.