ZDX V6-3.7L (2010)
12. Flip the MOTOR toggle switch to ON, and let the pump run for 5 minutes. While the pump is running, open and close the air purge valve
periodically. Always open the valve slowly. At the end of the 5-minute cleaning period, leave the air purge valve open.
NOTE: While the pump is running with the air purge valve open, it is normal to see vapor coming from the filler/breather tube vents.
13. With the air purge valve open, flip the MOTOR toggle switch to OFF. Leave the air purge valve open for at least 15 seconds to purge the lines and
hoses of residual ATF, then close the valve.
14. Disconnect the red and blue hoses from the ATF cooler lines.
15. Connect the red and blue hoses to each other.
16. Disconnect the shop air from the air purge valve. Disconnect and stow the coupler if used.
17. Disconnect and stow the fittings from the ATF cooler inlet and outlet lines.
18. Unplug the cooler cleaner from the 110 V outlet.
Tool Maintenance
Follow these instructions to keep the ATF cooler cleaner working properly:
-
Replace the two magnetic nonbypass spin-on filters after every 20 hours of use, based on the hour meter, or when you notice a restriction in the
ATF flow.
-
Check the level and condition of the fluid in the tank before each use.
-
Replace the ATF in the tank when it looks dark or dirty.