ZDX V6-3.7L (2010)
Axle Shaft Assembly: Testing and Inspection
Driveshaft Inspection
NOTE: Make sure to use silicone-type (gray) boot on the right front driveshaft inboard joint.
1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any
damage is found, replace the boot and the boot bands.
2. Check the driveshaft for cracks and damage. If any damage is found, replace the driveshaft.
3. Check the inboard joint (E) and the outboard joint (F) for cracks and damage. If any damage is found, replace the inboard joint or the outboard
joint as an assembly.
4. Hold the inboard joint and turn the front wheel by hand, then make sure the joint is not excessively loose. If necessary, replace the inboard joint or
the outboard joint as an assembly.
