ZDX V6-3.7L (2010)
Axle Shaft Assembly: Removal and Replacement
Intermediate Shaft Installation
Intermediate Shaft Installation
1. Clean the areas where the intermediate shaft contacts the differential thoroughly with solvent, and dry them with compressed air.
NOTE: Do not wash the rubber parts with solvent.
2. Install a new set ring (A) into the set ring groove (B) of the intermediate shaft (C).
3. Insert the intermediate shaft into the differential correctly.
NOTE: Insert the intermediate shaft carefully to prevent damaging the oil seal (D).
4. Install the flange bolt (A) and the two dowel bolts (B).
5. Install the rear warm up three way catalytic converter (rear WU-TWC) bracket (A).
