ZDX V6-3.7L (2010)
bonding the antenna bracket (E).
6. Carefully remove the rear fixed glass panel.
7. With a knife, scrape the old adhesive urethane path and hot melt patches smooth to a thickness of about 2 mm (0.08 in) on the bonding surface
around the entire rear fixed glass panel opening flange. Do not scrape down to the painted surface of the body; damaged paint will interfere with
proper bonding.
8. Clean the body bonding surface with a sponge dampened in isopropyl alcohol. After cleaning, do not allow oil, grease, and water to contact the
clean surface.
9. If the old rear fixed glass panel will be reinstalled, use a putty knife to scrape off the old adhesive urethane path and hot melt patches from the
panel. Clean the inside face and the edge of the panel with isopropyl alcohol where new adhesive will be applied. Make sure the bonding surface is
kept free of water, oil, and grease.
10. Scrape off the remaining double-sided adhesive tape from the antenna bracket, then clean the bracket surface with a sponge dampened in isopropyl
alcohol. After cleaning, do not allow oil, grease, and water to contact the clean surface.
11. Apply the new double-sided adhesive tape (A) to the antenna bracket (B).
