ZDX V6-3.7L (2010)
15. Hold the lower rear window with suction cups over the opening, align the clips, and set it down on adhesive. Lightly push on the lower rear
window until its edges are fully seated on adhesive all the way around.
NOTE: Do not open or close any of the doors for about an hour until adhesive is dry.
16. Remove the excess adhesive with a putty knife or a shop towel dampened in isopropyl alcohol.
17. Wait at least an hour for the adhesive to dry, then spray water over the lower rear window and check for leaks. Mark the leaking areas, let the
lower rear window dry, then seal with sealant. Let the vehicle stand for at least 4 hours after lower rear window installation. If the vehicle has to be
used within the first 4 hours, it must be driven slowly.
18. Reinstall all remaining removed parts.
NOTE: Advise the client not to do the following things for 2 to 3 days:
-
Slam the doors with all the windows rolled up.
-
Twist the body excessively (such as when going in and out of driveways at an angle or driving over rough, uneven roads).
