ZDX V6-3.7L (2010)
8. Install the glass and the regulator in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Make sure that each connector is plugged in properly.
-
Push the clips and the hook into place securely.
-
Make sure that there is no clearance between the glass and the glass run channel when the glass is closed.
-
Roll the glass up and down to make sure it moves freely without binding.
-
Adjust the position of the glass as necessary See: Window Glass/Front Door Window Glass/Adjustments.
-
Do the power window control unit reset procedure See: Power Window Control Module/Testing and Inspection.
-
Make sure the power door lock, the power window, and the power mirror operate properly.
-
When reinstalling the door panel, make sure the plastic cover on the door is installed properly and sealed around its outside perimeter to seal
out water.
-
Check for water leaks See: Window Glass/Front Door Window Glass/Adjustments.
-
Test-drive the vehicle, and check for wind noise and rattles.
