ZDX V6-3.7L (2010)
13. Remove the bolts (C), and loosen the bolt (D). Release the hook (E), then remove the regulator through the hole in the door.
14. Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.
15. Install the glass and the regulator in the reverse order of removal, and note these items:
-
If the clip is damaged or stress-whitened, replace it with a new one.
-
Make sure that each connector is plugged in properly.
-
Push the clips and the hooks into place securely.
-
Make sure that there is no clearance between the glass and the glass run channel when the glass is closed.
-
Roll the glass up and down to make sure it moves freely without binding.
-
Adjust the position of the glass as necessary See: Window Glass/Front Door Window Glass/Adjustments.
-
Make sure the power door lock and the power window operate properly.
-
When reinstalling the door panel, make sure the plastic cover on the door is installed properly and sealed around its outside perimeter to seal
out water.
-
Check for water leaks See: Window Glass/Front Door Window Glass/Adjustments.
-
Test-drive the vehicle, and check for wind noise and rattles.
