ZDX V6-3.7L (2010)
2. Install the windshield wiper motor to the wiper linkage assembly.
3. Connect the 5P connector to the wiper motor, and turn the wiper/washer switch ON to (LO) or (HI) position, then OFF to return the motor shaft to
the "Auto Stop Position".
NOTE:
-
Do not use the wiper/washer switch (INT) position in this step.
-
If necessary, replace any damaged clips.
-
Apply multipurpose grease to the moving parts.
4. Install the linkage and wiper linkage assembly in the reverse order of removal.
5. After installation, adjust the wiper arms See: Wiper Arm/Adjustments.
Replacement of the Wiper Motor Link Only
Removal
1. Pry the linkage from the link using a pry bar (A).
NOTE:
Be careful not to damage the rubber (B) and the linkage (C) with pry bar.
2. Replace the link: Remove the nut (A) and the link (B) from the motor (C).