Workshop Manuals Factory service & repair Alfa Romeo
01 General data and specifications02 Engine (Twin Spark, JTD and V6)03 Clutch04 Gearbox (manual, Selespeed and Q-System)05 Front axle06 Brakes, ABS and traction control07 Steering08 Suspension and wheels09 Heating, air conditioning and washers10 Electrical equipment11 Body12 Body panels and reinforcement13 Wiring diagrams14 Connectors and pin-outs15 Wiring harnesses16 Fault diagnosis17 Special tools
Alfa Romeo 156 Factory Service Manual (1997-2002)16 · Fault diagnosis
16 · Diagnostics

F01 Poor braking action

Make
Alfa Romeo
Model
156 Factory Service Manual
Year
1997–2002
Section
Brakes › F01 Poor braking action
Fault diagnosisF01 Poor braking action

F01 Poor braking action

As the pressure exerted on the brake pedal increases, the braking action does not correspond.

StepTest procedureResultAction
0PRELIMINARY CHECKS

Preliminarily, check the type, condition and inflation pressure of the tyres

OK

Move onto step 1

Pressure not correct
  • Restore the tyre inflation pressures

End of diagnosis

Tyres not suitable or worn
  • Replace the tyres

End of diagnosis

1CHECKING FOR BRAKE FLUID LEAKS

Visually inspect:

  • brake fluid level in the reservoir
  • for fluid leaks from the brake pump, lines or system connections
OK

Move onto step 2

Leaks in system
  • Tighten the connectors or replace the damaged parts (see Assembly 3340B)

End of diagnosis

2CHECK WITH DIAGNOSTIC EQUIPMENT

Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket

Check:

  • there are no faults in the ABS control unit
OK

Move onto step 3

An error is detected in the control unit
  • Continue according to the instructions for the diagnostic equipment

End of diagnosis

Lack of dialogue with the control unit

Restore:

  • the connection between the ABS control unit and the diagnostic connector
  • the supply for the ABS control unit (Wiring diagram E7020 ABS ).

End of diagnosis

3ACTIVE DIAGNOSIS WITH DIAGNOSTIC EQUIPMENT

Using the diagnostic equipment (Examiner or other instruments) carry out the active diagnosis of:

  • pump motor
  • solenoids
OK

Move onto step 4

Fault detected in the pump or a solenoid
  • Replace electrohydraulic unit-electronic control unit Op. 3340A10

End of diagnosis

4CHECK PAD TYPE AND SURFACE

Check:

  • condition of pad friction surfaces
  • pad type
OK

Move onto step 5

Friction surfaces vitrified or with traces of grease, oil or water
  • Clean, check and eliminate the causes of the fault

End of diagnosis

Front brake pads damaged or wrong type

End of diagnosis

Rear pads damaged or wrong type

End of diagnosis

5CHECK DISCS

Check condition of brake discs

OK

Move onto step 6

Front discs worn or damaged

End of diagnosis

Rear discs worn or damaged

End of diagnosis

6CHECK BRAKE CALIPERS

Check the condition of the brake caliper pistons

OK

Move onto step 7

Front caliper pistons worn or seized

End of diagnosis

Rear caliper pistons worn or seized

End of diagnosis

7CHECK BRAKE SERVO

Check that brake servo is working properly:

OK

Move onto step 8

Brake servo not working properly

End of diagnosis

8CHECK CORRECT OPERATION

Check that the fault is no longer present

OK

End of diagnosis

Fault persists

Incorrect selection of diagnostic procedure

Parts & tools for this job For 1997 Alfa Romeo 156

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.