Disconnect the mobile phone enabled by the Bluetooth® system and remove from inside the vehicle.

If the mobile phone is not removed from the vehicle and a call is received during the installation process, the procedure will not be successful.

Insert the USB pen in the USB port of the diagnostic instrument.

Insert the update CD in the tester, then turn on.

Select the language in which instructions are to be read.

When the final user licence appears, press I Accept.

The USB pen is not supported by the diagnostic tester or software: use a compatible USB pen.

Pens supported are with standard USB 1.0, 1.1 or 2.0 connectors and capacity up to 1 GB. The following models are certainly supported: Lexar™ JumpDrive® 2.0 512 MB, Memorex® Travel Driver 256 MB USB 2.0, Memorex® Travel Driver 1 GB USB 2.0, PNY® Attaché 256 MB USB 2.0, SanDisk® Cruzer™ micro 256 MB USB 2.0, SanDisk® Cruzer™ Mini 256 MB / 1 GB USB 2.0 and Sony® Micro Vault®

Press the START/STOP button (panel off).

Remove the radio

Op. 5570T80 CAR RADIO EQUIPMENT - R+R

Press the START/STOP button (panel off).

Check hat the message "Install language <selected language>? appears on the panel.

The procedure will not be successful if the USB pen is removed during the installation procedure. Re-insert the pen, wait for 30 seconds and repeat this step

If a software update is available, install by running the test

See Test 5570TP BLUETOOTH SOFTWARE UPDATING PROCEDURE

Press the START/STOP button (panel off).

Wait 3 minutes.

Press the START/STOP button (panel on) and check that the language update is complete