Power unit intermediate mount flexible block - replace
- Make
- Alfa Romeo
- Model
- 159 Factory Service Manual
- Year
- 2005–2011
- Section
- Power unit supports › Power unit intermediate mount flexible block - replace
POWER UNIT INTERMEDIATE MOUNT FLEXIBLE BLOCK - REPLACE
Removing
Op. 4450B12 FRONT WHEELS (TWO) - R+R
Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R
Op. 4410D10 FRONT SUSPENSION FRAME - R+R
(proceed with the removal only without carrying out the dismantling at the bench).
Op. 4410C10 FRONT SUSPENSION ANTI-ROLL BAR - R+R - CHECK WHEEL GEOMETRY SEPARATELY
Mark the position of the flexible mounting for the power unit rear support in relation to the front suspension frame.
1. Undo the bolts (1a) and remove the flexible mounting for the power unit rear support (1b) from the front suspension frame.
Refitting
1. Place the power unit rear support flexible mounting (1a) in its housing and secure it by tightening the new bolts (1b) to the recommended torque.
| Component | Fastening | dia | Value (daNm) | Validity |
|---|---|---|---|---|
| Power unit rigid rear support flexible mounting | Bolt (to be replaced) | M12 | (front suspension frame side) 6.3 - 7.7 + 60° |
Op. 4410C10 FRONT SUSPENSION ANTI-ROLL BAR - R+R - CHECK WHEEL GEOMETRY SEPARATELY
Op. 4410D10 FRONT SUSPENSION FRAME - R+R
Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R
Op. 4450B12 FRONT WHEELS (TWO) - R+R
Removing
Op. 4450B12 FRONT WHEELS (TWO) - R+R
Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R
Op. 4410D10 FRONT SUSPENSION FRAME - R+R
(proceed with the removal only without carrying out the dismantling at the bench).
Op. 4410C10 FRONT SUSPENSION ANTI-ROLL BAR - R+R - CHECK WHEEL GEOMETRY SEPARATELY
Mark the position of the flexible mounting for the power unit rear support in relation to the front suspension frame.
1. Undo the bolts (1a) and remove the flexible mounting for the power unit rear support (1b) from the front suspension frame.
Refitting
1. Place the power unit rear support flexible mounting (1a) in its housing and secure it by tightening the new bolts (1b) to the recommended torque.
| Component | Fastening | dia | Value (daNm) | Validity |
|---|---|---|---|---|
| Power unit rigid rear support flexible mounting | Bolt (to be replaced) | M12 | (front suspension frame side) 6.3 - 7.7 + 60° |
Op. 4410C10 FRONT SUSPENSION ANTI-ROLL BAR - R+R - CHECK WHEEL GEOMETRY SEPARATELY
Op. 4410D10 FRONT SUSPENSION FRAME - R+R
Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R
Parts & tools for this job For 2005 Alfa Romeo 159
- PARTEngine gasket setSearch: Alfa Romeo 159 2005 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.