Workshop Manuals Factory service & repair Alfa Romeo
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Transmission (4x4)12 Axles and driveshafts13 Brakes14 Steering15 Suspension and wheels16 Heating, air conditioning and auxiliary units17 Electrical equipment18 Body fittings19 Body panels and frame20 Wiring diagrams and electrical functions21 Wiring harnesses22 Connectors and pin-outs23 Fault diagnosis24 Special tools
Alfa Romeo Brera and Spider Factory Service Manual (2005-2010)23 · Fault diagnosis
23 · Diagnostics

Tilt sensor alarm not working

Make
Alfa Romeo
Model
Brera and Spider Factory Service Manual
Year
2005–2010
Section
Alarm › Tilt sensor alarm not working
Fault diagnosisTilt sensor alarm not working

TILT SENSOR ALARM NOT WORKING

The anti-tilt sensor is located under the centre console and is connected to the Body Computer by means of the dialogue line known as the A-BUS. The tilt sensor is operated and controlled by the Body Computer Node via a series of encrypted messages and can be excluded by the customer using the special button. If there is a failure the Body Computer Node detects and memorizes the causes of the malfunction

Test results
1CHECK USING DIAGNOSTIC EQUIPMENTAll OKProblems encounteredOperation

Connect the diagnostic equipment to the diagnostic socket and check the following at the Body Computer Node in parameters ambient:

- the presence of the tilt sensor

In errors ambient:

- that there are no problems relating to the tilt sensor

Move on to Step 2Tilt sensor excluded manuallySwitch on tilt sensor
Tilt sensor not presentCheck the conformity of the vehicle
Presence of faultsProceed as instructed by the diagnostic tester
2TILT MODULE POWER SUPPLY CHECKAll OKProblems encounteredOperation

Check that the anti-tilt module is correctly supplied

See E7015 ALARM

Move on to Step 3Supply not correctRestore correct power supply
3CHECK USING DIAGNOSTIC EQUIPMENTAll OKProblems encounteredOperation

Connect the diagnostic equipment to the diagnostic socket and check the following at the Body Computer Node. In active diagnosis:

- the operation of the tilt module

- the condition of the A-Bus serial line

Move on to Step 4A-BUS serial line interruption

Restore the correct serial line

See E7015 ALARM

Anti-tilt module defectiveReplace the tilt sensor
4CHECK ON CORRECT OPERATIONAll OKProblems encounteredOperation
Check that the fault is no longer presentEnd of diagnosisThe fault persists

Replace Body Computer

Op. 5505A32 BODY COMPUTER - R.R

Parts & tools for this job For 2005 Alfa Romeo Brera

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.