Rear suspension stabilizer bar - r+r
- Make
- Alfa Romeo
- Model
- GT Factory Service Manual
- Year
- 2003–2010
- Section
- Rear suspension › Rear suspension stabilizer bar - r+r
‹ Prev L/h and r/h rear suspension wishbones - r+r and stripNext › Rear suspension anti-roll bar joints (lh and rh) - r r
Suspension and wheelsRear suspension stabilizer bar - r+r
REAR SUSPENSION STABILIZER BAR - R+R
Removing
Position the vehicle on the ramp
1. Undo the nuts securing the rear suspension anti-roll bar joints to the antiroll bar.
2. Undo bolts (2a) and remove rear suspension antiroll bar (2b) complete with mounting blocks (2c).
Refitting
1. Refit rear suspension antiroll bar (1a), complete with mounting blocks, and secure it by tightening the bolts (1b) to the recommended torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| 1b |
2. Tighten the nuts securing the rear suspension antiroll bar joints to the antiroll bar to the specified torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| 2 | Nut | REAR ANTI-ROLL BAR PIVOTS | M10 | Anti-roll bar/shock absorber side.) 4.1 ÷ 5.0 |
Remove the car from the ramps.
‹ Prev L/h and r/h rear suspension wishbones - r+r and stripNext › Rear suspension anti-roll bar joints (lh and rh) - r r
Parts & tools for this job For 2003 Alfa Romeo GT
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTRear shock absorbersSearch: Alfa Romeo GT 2003 rear shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.