200 Quattro Wagon L5-2226cc 2.22L SOHC Turbo (MC) (1989)
9 - Bolt
mounts overcenter spring on clutch pedal
10 - Brake pedal return spring
attach one end to brake pedal and other end to pedal bracket
11 - Brake pedal
mount on pedal bracket shaft
install with pressed-in bearing bushing
pedal with molded-in bearing bushing will be phased in gradually
12 - Circlip
always replace
install on pedal bracket shaft
13 - Clips
for brake light switches
install in pedal bracket
14 - Brake light switch
adjusting:
operate brake pedal
press brake light switch in to stop
press brake pedal back to stop by hand
15 - Washer
16 - Self-locking nut 25 Nm (18 ft lb)
always replace
17 - Bolt
mount clevis on clutch pedal
bolt can also be installed turned 180°
18 - Clevis
adjust via push rod until clutch pedal is approximately 10mm above brake pedal
check that overcenter spring returns clutch pedal
check that clutch pedal in rest position does not contact pedal bracket
19 - Lock nut
tighten aher adjusting clevis
20 - Master cylinder
21 - 20 Nm (15 ft lb)
mounts master cylinder to pedal bracket
22 - Circlip
always replace
install on bolt