5000CS Turbo L5-2226cc 2.22L SOHC Turbo (MC) (1987)
Installing
^
remove plugs from high pressure hose and pressure accumulator
^
clean seal contact surface on pressure accumulator thoroughly
^
feed high pressure hose into engine compartment from underneath
CAUTION
DO NOT interchange banjo bolts 2 and 12.
2 = damper pipe to central hydraulic pump
12 = high pressure hose to accumulator
^
connect high pressure hose to pressure accumulator with new banjo bolt 12 and new seals. Hold accumulator with oil filter wrench when tightening
bolt
Note
The metal connection on the damper hose must make contact with the stop pin on the accumulator.
When tightening the connection, the banjo bolt must be in a vertical position.
^
carefully insert new damper hose into new damper pipe
^
thread union together by hand but DO NOT tighten
^
remove plug from central hydraulic pump and clean seal contact surface thoroughly
^
remove plug from damper pipe
CAUTION