Audi Workshop Service and Repair Manuals

Removing and installing glass panel Removing

–  Slide open panel approx. 150 mm to the rear.

–  Remove bolts from bottom of panel -arrow- on both sides.   Caution Seal opening between A-pillar and sunroof frame with cloth, paper or similar to prevent any bolts from falling into vehicle.

–  Unscrew bolts (front) -arrow- from panel on both sides.

–  Loosen bolts -arrow- in centre of panel, but do not remove.

–  Lift panel out of guide plates with the help of a second person.   Note To avoid damage to the guides, always run them to the »roof closed« position after removing the panel.

Move guides -1- to »roof closed« position. Installing

–  Slide guide plates approx. 150 mm to the rear. –  Lift panel onto guide plates with the help of a second person.

–  Position panel frame so that recesses -arrow- are in line with the loosened bolts.   Note Observe tightening sequence. –  First tighten bolts at rear, then at front and finally in centre. –  Close panel and check alignment with roof. –  If necessary, open and adjust panel. –  Tighten bolts to specified torque.