audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing centre console > < Removing and installing storage net

A1

Retrofitting storage net
Retrofitting storage net
Special tools and workshop equipment required
   
t  Pop rivet tool -VAS 5072-
t  Drill (angular drill or angular drill attachment)
t  Bit Ø 3.5 mm
t  Safety goggles
  W00-1237
Sequence of operations
–  Remove the centre console → Chapter.
–  Set down the centre console on a firm, clean surface.
  WARNING
Risk of eye injury.
Wear safety goggles.
–  Use a Ø 3.5 mm bit to carefully drill 5 holes at the marks -arrows- on the inside of the centre console.
  A68-10537
–  Starting in the centre, rivet the frame -1- with storage net to the centre console using the pop rivet tool -VAS 5072--arrows-.
–  Engage the trim -2- at the top of the frame and press on until heard to engage.
–  Install the centre console → Chapter.
Notes on installation: For example tightening torques, component replacement → Chapter.
  A68-10538

Removing and installing centre console > < Removing and installing storage net