A1
|
| 1 - | Protective cap |
| q | Fit onto bleeder valve |
| 2 - | Bleeder screw |
| q | Before screwing in, grease thread with thin coat of lithium grease -G 052 150 A2-. |
| q | 10 Nm |
| 3 - | Caps |
| q | Insert into bearing bush |
| 4 - | Guide pin |
| q | 30 Nm |
| 5 - | Bearing bush |
| q | Insert into brake caliper housing |
| 6 - | Brake caliper housing |
| 7 - | Brake carrier |
| q | Bolted to brake caliper housing |
| 8 - | Retaining spring |
| q | Insert both ends in holes in brake caliper housing |
| 9 - | Seal |
| q | Do not damage when inserting piston |
| q | Removing and installing → Chapter |
| 10 - | Piston |
| q | Apply a thin coat of lithium grease -G 052 150 A2- to piston |
| q | Removing and installing → Chapter |
| 11 - | Protective cap |
| q | Push outer sealing lip onto piston |
| q | Do not damage when inserting piston |
| q | Before removing and installing, first remove piston → Chapter |
