A1
| Exploded view - flange shafts and oil seals |
| 1 - | Circlip |
| q | Holds tapered ring, thrust washer and spring in position when flange shaft is removed |
| 2 - | Spring |
| q | For flange shaft |
| 3 - | Thrust washer |
| q | Installation position: lip faces spring |
| 4 - | Tapered ring |
| q | Installation position: Taper towards differential cage |
| 5 - | Oil seal |
| q | For flange shaft (right-side) |
| q | Renewing → Chapter |
| 6 - | Flange shaft (right-side) |
| q | Removing and installing → Chapter |
| 7 - | Countersunk bolt |
| q | 25 Nm |
| 8 - | Circlip |
| q | Holds tapered ring, thrust washer and spring in position when flange shaft is removed |
| 9 - | Tapered ring |
| q | With grooves to engage on thrust washer |
| q | Installation position: Taper towards differential cage |
| 10 - | Thrust washer |
| q | Installation position: lip faces spring |
| 11 - | Spring |
| q | For flange shaft |
| 12 - | Oil seal |
| q | For flange shaft (left-side) |
| q | Renewing → Chapter |
| 13 - | Flange shaft (left-side) |
| q | Removing and installing → Chapter |
| 14 - | Countersunk bolt |
| q | 25 Nm |