audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing oil seal for flange shaft (left-side) > < Removing and installing flange shaft (left-side)

A1

Removing and installing flange shaft (right-side)
Removing and installing flange shaft (right-side)
   
Removing
l  Gearbox in vehicle
–  Remove noise insulation -1- → General body repairs, exterior; Rep. gr.66.
–  Unbolt drive shaft (right-side) from flange shaft on gearbox → Running gear; Rep. gr.40.
–  Tie up drive shaft (right-side).
  Note
Make sure you do not damage surface coating on drive shaft.
  A10-11347
–  Remove bolt -arrow- securing flange shaft (right-side). To do so, screw 2 bolts into flange and counterhold flange shaft with suitable lever.
–  Pull out flange shaft together with spring, thrust washer and tapered ring.
Installing
l  Tightening torque → Chapter „Exploded view - flange shafts and oil seals“
Installation is carried out in reverse sequence; note the following:
–  Push flange shaft in against spring pressure and secure with bolt.
–  Secure drive shaft (right-side) to flange shaft on gearbox → Running gear; Rep. gr.40.
–  Install noise insulation → General body repairs, exterior; Rep. gr.66.
  A34-0691

Renewing oil seal for flange shaft (left-side) > < Removing and installing flange shaft (left-side)