A1
Exploded view - mechatronic unit for dual clutch gearbox -J743- |
1 - | Bolt |
q | 8 Nm |
2 - | Cover |
q | Over clutch actuator levers |
q | Depending on version |
3 - | Bolt |
q | Qty. 3, M8 x 35 |
q | Renew |
q | Tightening torque and sequence → Fig. |
4 - | Bolt |
q | Qty. 4, M8 x 90 |
q | Renew |
q | Tightening torque and sequence → Fig. |
5 - | Mechatronic unit for dual clutch gearbox -J743- |
q | → Chapter „Safety notes on mechatronic unit for dual clutch gearbox -J743-“ |
q | → Chapter „Removing and installing mechatronic unit for dual clutch gearbox -J743- with gearbox installed“ |
q | → Chapter „Moving mechatronic unit for dual clutch gearbox -J743- into removal position by hand“ |
Note
|
Stage | Bolts | Tightening torque |
1. | -A- | Screw in bolts by hand until they make contact |
2. | Remove guide pin -T10406- | |
3. | -B- | Screw in bolts by hand until they make contact |
4. | -A, B- | 10 Nm in diagonal sequence |