A1
| Exploded view - subframe, swivel joint, wishbone, anti-roll bar, coupling rod |
| 1 - | Subframe |
| q | Removing and installing → Chapter |
| q | Different versions available |
| q | For correct version refer to → Electronic parts catalogue „ETKA“ |
| 2 - | Nut |
| q | 40 Nm |
| q | Always renew if removed |
| 3 - | Anti-roll bar |
| q | Removing and installing → Chapter |
| The subframe must be lowered to remove and install |
| 4 - | Rubber bush |
| q | Removing and installing → Chapter |
| q | Always renew on both sides |
| q | For correct version refer to → Electronic parts catalogue „ETKA“ |
| 5 - | Clamp |
| 6 - | Nut |
| q | 40 Nm |
| q | Always renew if removed |
| 7 - | Coupling rod |
| q | Removing and installing → Chapter |
| 8 - | Nut |
| q | Always renew if removed |
| 9 - | Support |
| 10 - | Bolt |
| q | 20 Nm +90° |
| q | Always renew if removed |
| If the thread of the welded nut is damaged, the thread can be repaired with a Heli-Coil thread insert → Chapter |
| 11 - | Bolt |
| q | 70 Nm +90° |
| q | Always renew if removed |
| If the thread of the welded nut is damaged, the thread can be repaired with a Heli-Coil thread insert → Chapter |
| 12 - | Bonded rubber bush (rear) |
| q | Renewing → Chapter |
| q | Different versions possible. For correct version refer to → Electronic parts catalogue „ETKA“ |
| q | Note correct installation position (depending on version) |
| 13 - | Wishbone |
| q | Removing and installing → Chapter |
| 14 - | Nut |
| q | 50 Nm +90° |
| q | Always renew if removed |
| 15 - | Swivel joint |
| q | Removing and installing → Chapter |
| 16 - | Nut |
| q | 100 Nm |
| q | Always renew if removed |
| 17 - | Bolt |
| q | 70 Nm +90° |
| q | Always renew if removed |
| 18 - | Bonded rubber bush (front) |
| q | Renewing → Chapter |
| 19 - | Bolt |
| q | 70 Nm +90° |
| q | Always renew if removed |
| 20 - | Bolt |
| q | 70 Nm +90° |
| q | Always renew if removed |
| 21 - | Hexagon bolt |
| q | 20 Nm +90° |
| q | Always renew if removed |
| 22 - | Hexagon bolt |
| q | 40 Nm +90° |
| q | Always renew if removed |
| 23 - | Hexagon bolt |
| q | 30 Nm + turn 90° further |
| q | Always renew if removed |
| 24 - | Pendulum support |
| q | Different versions available |
| q | For correct version refer to → Electronic parts catalogue „ETKA“ |
