A1
| Exploded view - motor/pump unit |
| t | There is no provision for repairing the motor/pump unit. |
| t | If problems are reported, determine the cause by means of a pressure test and a leakage test. |
| t | Always check the steering system for leaks if the hydraulic fluid level in the reservoir is low. |
| t | In the event of any leaks near line connections, re-tighten connections and wipe dry. |
| t | Do not re-use hydraulic fluid which has been drained off. |
| t | Always renew seals. |
| t | Quantity of fluid in system: approx. 0.8 ltr. |
| 1 - | Cap with dipstick |
| q | Checking hydraulic fluid level → Chapter |
| 2 - | Seal |
| 3 - | Fluid reservoir |
| q | Renewing → Chapter |
| 4 - | Clamp |
| q | 3 Nm |
| q | For correct version refer to → Electronic parts catalogue „ETKA“ |
| 5 - | Seal |
| q | For correct version refer to → Electronic parts catalogue „ETKA“ |
| q | Always renew if removed |
| 6 - | Motor/pump unit |
| q | With power steering control unit -J500- |
| q | No provision for repair |
| q | Only the fluid reservoir → Item, clamp → Item and seal → Item can be renewed. |
| q | Removing and installing → Chapter |
| q | Checking delivery pressure → Chapter |
| 7 - | Mounting |
| q | Tightening torque: 7 Nm |
| q | Check for damage, such as cracks in rubber, separation of metal plate from rubber etc. and renew as required |
| 8 - | Nut |
| q | 7 Nm |
| q | When tightening, counterhold at mounting → Item |
| 9 - | Bolt |
| q | 20 Nm +90° |
| q | Always renew if removed |
| 10 - | Bracket |
| q | For motor/pump unit |
| q | Different versions available |
| q | For correct version refer to → Electronic parts catalogue „ETKA“ |
| 11 - | Pressure line |
| 12 - | Union screw |
| q | 30 Nm |
| 13 - | Seal |
| q | Always renew if removed |
| 14 - | Spring-type clip |
| 15 - | Return line |
