audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing control unit for daytime running light and side light J860/J861 > < Renewing gas discharge bulb L13/L14

A1

Renewing LED module for daytime running light and side light L176/L177
Renewing LED module for daytime running light and side light -L176-/-L177-
   
Removing
–  Remove headlight housing → Chapter.
LED module (top):
–  Remove bolts -arrows-.
–  Detach LED module -3- from headlight housing.
–  Unplug electrical connector -2-.
  A94-10970
LED module (bottom):
–  Remove gas discharge bulb control unit → Chapter.
–  Remove bolts -1, 6-.
–  Pull out LED module -5--arrow A-, rotate around attachment point -4- for gas discharge bulb control unit -arrow B- and lift off.
–  Unplug electrical connector -2-.
  A94-10971
Installing
l  Tightening torque → Chapter
Installation is carried out in the reverse order; note the following:
LED module (top):
–  Check seal -1- between LED module and headlight housing for damage.
  A94-10970
LED module (bottom):
–  Check seal -3- between LED module and headlight housing for damage.
–  Install gas discharge bulb control unit → Chapter.
  A94-10971

Removing and installing control unit for daytime running light and side light J860/J861 > < Renewing gas discharge bulb L13/L14