Removing and installing release mechanism |
–
| Remove backrest section cover panel → Chapter. |
–
| Mark position of bolts. |
–
| Unscrew bolts -2- (2x). |
–
| Tightening torque 21 Nm |
–
| Tightening torque 21 Nm |
–
| Screw in bolt -3- and tighten to 21 Nm. |
–
| Screw in and hand-tighten bolts -2-. |
–
| Fit backrest section cover panel → Chapter. |
–
| By turning release mechanism -1-, set release mechanism -1- such that release handle moves freely (tap with hammer). |
–
| Fit seat in vehicle and align backrest section cover panel in parallel with adjacent seat. |
–
| Align backrest latch with striker plate and backrest section. |
–
| Tighten bolts -2- to 21 Nm. |
|
|
|