|
Component overview, ABS/ESP Mark 20
Adjusting brake light switch
Removing and installing
Remove brake light switch to adjust.
-
‒ Unplug connector from brake light switch.
-
‒ Remove brake light switch by turning through 90°-clockwise.
-
‒ Pull brake light switch plunger fully out.
-
‒ Press brake pedal down as far as possible by hand.
-
‒ Guide brake light switch through assembly opening and re-install by turning 90°-anti-clockwise.
-
‒ Release brake pedal.
-
‒ Plug in connector for brake light switch.
-
‒ Operate brake pedal.
=>Brake lights light up.
-
‒ Take foot off brake pedal.
=>Brake lights must not light up.
| 