audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Table of the codes displayed in display zone 4 of display group 014 > < Display group 013:

A2

Display group 014:
Display group 014:
“Ignition-off” time-span, ignition key assignment, windscreen wiper operation signal and the encoding transmitted by the control unit in the dash panel insert -J285-
   
Display zoneMeaningExplanatory Notes
1Period of time transmitted by the control unit in the dash panel insert -J285- for the interval between the ignition being switched on and off
t  Display = 00:00....03:59 h
–  Ignition-off period (stationary time) in hours and minutes
l  Data is transmitted via the convenience data bus
2Ignition key assignment transmitted by the control unit in the dash panel insert -J285-
t  Display = 0
–  The ignition was switched on with a key for which there is no assignment in thecontrol unit in the dash panel insert -J285-.
t  Display = 1, 2....
–  The ignition was switched on with the key which was set to position 1 (2, 3 or 4) in the control unit in the dash panel insert -J285-.
l  Data is transmitted via the convenience data bus
l  Check the matching of the ignition key. → Electrical System; Repair group 90
l  Up to 4 keys can be assigned

  Note
t  If the operating and display unit for air conditioner/Climatronic -E87- does not detect an “ignition-off period” signal when the ignition is switched on, the operating and display unit for air conditioner/Climatronic -E87- assumes that the vehicle has been standing for more than 4 hours, and that the engine temperature is the same as the ambient temperature. Possible consequences: (the fresh-air blower may be delayed in starting up, even though the engine is warm, the ambient temperature display -G106- in the control unit in the dash panel insert -J285- may indicate incorrect ambient temperature readings).
t  The ignition key assignment can only be detected and thus transmitted by control unit in the dash panel insert -J285- in vehicles fitted with an immobilizer. → Electrical System; Repair group 90; Repairing the dash panel insert
t  When the ignition is switched on, the operating and display unit for air conditioner/Climatronic -E87- starts with the setting which was valid when the ignition was last switched off using the key concerned (temperature, air distribution, fresh-air blower speed).
   
Display zoneMeaningExplanatory Notes
3Signal for the windscreen wiper operating status (voltage at terminal “31 b”)
t  Display = 0
–  Windscreen wipers or wiper/washer system are not switched on (wipers in park position)


–  Earth is applied to connector “C”, contact “14” for the operating and display unit for air conditioner/Climatronic -E87- (via the windscreen wiper motor)
 
t  Display = 1
–  Windscreen wipers or wiper/washer system are switched on
–  There is no earth applied to connector “C”, contact “14” for the operating and display unit for air conditioner/Climatronic -E87-
4Encoding transmitted by the control unit in the dash panel insert -J285- and by the central control unit for the convenience system -J393-
t  Display = XX XXX
–  Explanatory notes → Chapter
–  For example: Display “00 000” = A vehicle for Germany with a petrol engine and a central control unit for convenience system -J393- for a LHD vehicle
l  Data is transmitted via the convenience data bus
l  If the encoding deviates from the details in the table → Chapter, check the encoding of the control unit in the dash panel insert -J285- and the assignment of the central control unit for the convenience system -J393- → Electrical System; Repair group 01 and → Parts List

   

Table of the codes displayed in display zone 4 of display group 014 > < Display group 013: