A2
|
|
|
1 - | Sleeve |
q | For selector shaft |
q | Driving out → Fig. |
q | Driving in → Fig. |
2 - | Selector shaft with selector mechanism cover |
q | Renew together |
3 - | Locking pin |
q | For adjusting selector mechanism |
q | Removing → Fig. |
q | Driving in → Fig. |
4 - | Relay lever |
q | Installation position → Fig. |
5 - | Bearing bush |
6 - | Seal |
q | Lever out with screwdriver |
q | Fitting → Fig. |
7 - | Cap |
q | For gearbox breather |
8 - | Gearbox selector lever |
q | Install so that gap in splines aligns with selector shaft → Fig. |
q | Can be renewed with selector mechanism installed |
q | Installation position → Fig. |
9 - | Nut |
q | 20 Nm |
q | Self-locking |
q | Always renew |
10 - | Securing clip |
|
|
|
|