A2
| Exploded view - clutch release mechanism |
Note| t | Remove the gearbox when working on the release shaft and release bearing → Chapter. |
| t | Coat all bearing and contact surfaces with high-temperature grease -G 000 603-. |
| 1 - | Release shaft |
| q | Check for ease of movement |
| 2 - | Oil seal |
| q | Lever out with screwdriver |
| q | Installing → Fig. |
| 3 - | Bearing bush |
| q | Removing → Fig. |
| q | Installing → Fig. |
| 4 - | Clutch housing |
| q | Servicing → Chapter |
| 5 - | Bearing bush |
| q | Removing → Fig. |
| q | Installing → Fig. |
| 6 - | Retaining clip |
| q | Prise out before removing release shaft |
| 7 - | Release lever |
| q | Assembling with release shaft → Fig. |
| 8 - | Release bearing |
| q | Do not wash out bearing; wipe clean only |
| q | Renew bearing if noisy |
| 9 - | Retaining clip |
| q | Attach to release bearing |
| 10 - | Retaining spring |
| q | Insert in retaining clip and then in release lever |
| 11 - | Bolt |
| q | Self-locking |
| q | Renew |
| q | 18 Nm |
| 12 - | Guide sleeve |
| q | Grease release bearing guide |
