Release fasteners -arrows- and remove noise insulation.
–
Release retaining clips -arrows- and detach cover (top) for toothed belt.
–
Rotate crankshaft in normal direction of rotation to „TDC“.
l
Notch on crankshaft pulley must align with edge of marking -O-.
l
The locating holes in the camshaft sprockets must align with the corresponding holes in the camshaft housing -arrows-.
Note
If the locating holes are positioned on the opposite side, the crankshaft must be turned one revolution further.
–
Lock camshafts using camshaft lock -T10016-:
l
It should be possible to insert one locking pin through the locating hole in the inlet camshaft sprocket -C- and into the corresponding hole in the camshaft housing.
l
It should be possible to insert the second locking pin through the locating hole in the exhaust camshaft sprocket and into the corresponding hole in the camshaft housing.
l
The knobs on locking pins must be on a level -line A-.
Assembling
Installation is carried out in the reverse order; note the following: