t
| Replace the hexagon socket nut -B- (pressed-steel version) with a 12-point nut -A- on both sides of the vehicle. Do not install the pressed-steel type hexagon socket nut. |
t
| Degrease thread on outer joint (stub axle) before installing. |
–
| Always install a new 12-point nut. |
Do not apply grease to thread on drive shaft. |
–
| Use socket (36 mm) -T10125- |
–
| If fitted, attach guard plate to pendulum support. |
–
| If fitted, attach guard plate above drive shaft to engine. |
–
| Install noise insulation. |
After installation, check position of steering wheel by test-driving vehicle. |
Wheel alignment must be checked and adjusted if steering wheel is not in central position when driving straight-ahead. |
–
| Check and adjust wheel alignment → Chapter. |
|
|
|