Workshop Manuals Factory service & repair Audi
01 Running gear02 Body03 Power unit04 Power transmission05 Vehicle electrics06 Heating, ventilation, air conditioning system
Audi A201 · Running gear
01 · Steering & suspension

Running gear, front-wheel drive (General notes): Technical data

Make
Audi
Model
A2
Section
Running gear, front-wheel drive › Technical data › General notes
Running gearGeneral notes
General notes
Load-bearing components and parts of the suspension or steering must not be welded or straightened.
Bonded rubber bushes can only be turned to a limited extent. The bolt connections on the suspension links should therefore only be tightened when the vehicle is standing on the ground.
If the wheel alignment has to be checked and adjusted at a later stage, all bolts and nuts which need to be slackened to make adjustments should initially only be tightened to the specified torque figure. After wheel alignment has been checked and adjusted, bolts and nuts must then be fully tightened by turning them through the specified angle.
Running gear, front-wheel drive (General notes): Technical data – Audi A2   Caution
All bolts and nuts must be fully tightened according to specifications before the vehicle is driven on public roads.
   

Parts & tools for this job For Audi A2

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.