Note | The setting dimensions indicate the values for a moving vehicle, i.e. the spray from the jets is slightly offset when the vehicle is stationary. |
| –
| Use water-soluble pen to mark four points on windscreen: |
| l
| Dimension -a- = 240 ... 280 mm. |
| l
| Dimension -b- = 470 ... 535 mm |
| l
| Dimension -c- = 560 … 580 mm |
| –
| Using setting tool -T10127-, target points from individual spray jets. |
| –
| If the spray area is not as specified, the spray jet is dirty and must be cleaned. |
| –
| Flush out the spray jet with clean water opposite to the spray direction. |
| –
| To remove any residual contamination, compressed air can be blown through the spray jet, but only opposite to the spray direction. |
| If the spray area is still not as specified. |
|
|
|
