Audi Workshop Service and Repair Manuals

Removing and installing filler neck with flexible pipe for washer fluid container Special tools and workshop equipment required

t  Pressing lever -80 - 200-

t  Hose clamp fitting tool -V.A.G 1921-

Removing –  Wash and rub dry the outside of the bonnet. –  Release the service flap from inside. –  Release the bonnet -arrows- and pull it forwards slightly.

–  Fit the protective cover -VAS 6011- over the bonnet.   Note

Do not stand the bonnet on end. –  Detach the bonnet and set it down on the protective cover -VAS 6011-.

–  Remove the left wheel housing liner → Rep. Gr.66. –  Pull the flexible pipe of the filler neck -1- out of the washer fluid reservoir -4- at the location marked -A-. –  Press off the hose holders -2- with the pressing-off lever -80 - 200-.   Note t  Ignore -item 3-. t  Use silicone-free lubricant spray to facilitate removal if necessary.

–  Swivel the filler neck for the washer fluid reservoir forwards -arrow-. –  Press the pins of the expanding clips -1- and -2- towards the engine compartment. –  Remove the filler neck for the washer fluid reservoir together with the flexible pipe. Installing Install in reverse order, paying attention to the following: –  Fit the left wheel housing liner → Rep. Gr.66.