audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing left A-pillar connection point > < Removing and installing fuse carrier on 9-socket relay carrier

A2

Removing and installing 9-socket relay carrier
Removing and installing 9-socket relay carrier
Removing
  Caution
On vehicles with telematics system, activate service mode of telematics control unit before disconnecting battery → Radio, telephone, navigation, self-diagnosis; Rep. Gr.01.
–  With the ignition switched off, disconnect the earth wire at the battery → Chapter.
   
–  Press the light switch -arrow 1- and at the same time turn it to the right -arrow 2-.
–  Hold the switch in this position and pull it out of the switch housing -arrow 3-.
–  Unplug the connectors.
  A96-0390
–  Remove the driver's storage compartment → Rep. Gr.68.
–  Remove nuts -arrows-.
–  Remove 9-socket relay carrier -1-.
–  Unclip fuse carrier -2- from 9-socket relay carrier.
–  Detach relays and control units and then unclip the appropriate relay carrier.
  Note
Exact assignment for relay carrier and fuse carrier can be found on appropriate current flow diagram → Current flow diagrams, Electrical fault finding and Fitting locations.
Installing
Install in reverse order, paying attention to the following:
–  Fit the driver's storage compartment → Rep. Gr.68.
–  Install the light switch → Chapter.
–  Connect the battery. Action to be taken → Anchor.
Tightening torque
  A97-1129
ComponentNm
Fuse carrier to 9-socket relay carrier2
9-socket relay carrier to central tube 2

   

Removing and installing left A-pillar connection point > < Removing and installing fuse carrier on 9-socket relay carrier