A3 L4-2.0L Turbo (BPY) (2006)
-
Disconnect harness connector of sensor wire at steering pinion.
Press terminal off spiral spring housing, using screwdriver (blade width 3 mm), as shown in illustration.
-
Pull out locking mechanism out of steering gear housing.
-
Pull sensor wire out of steering gear housing.
Installing
-
Guide sensor wire into steering gear housing.
-
Secure spiral spring - arrow - with sensor wire to steering gear housing.
-
Insert terminal into spiral spring housing.
Terminal is coded and can only be installed in one direction.
-
Disconnect old harness connector from control module.
-
Press button - a - in direction of - arrow - and disconnect connector to do so.
-
Insert wires of new sensor wiring into new connector housing.
-
Use details on old connector terminal for coding.