A3 L4-2.0L Turbo (BPY) (2006)
‹› When performing work in the footwell, place rags on the carpet to protect it from possible brake fluid spills.
-
Remove nuts - 2 -.
-
Remove mounting bracket - 1 -.
Installing
‹› Tightening specification. Refer to => [ Pedal Assembly and Clutch Master Cylinder Assembly Overview ] See: Pedal Assembly and Clutch Master
Cylinder Assembly Overview.
Install in reverse order, paying attention to the following:
‹› Replace self-locking nuts.
‹› Secure all hose connections with hose clamps of the same type as those equipped by the factory.
-
Insert mounting bracket - 1 - and tighten nuts - 2 -.
-
Install the either the hose/line assembly of the plastic hose. Refer to => [ Hose/Line Assembly or Plastic Hose ] See: Clutch Hydraulic
System/Hydraulic Hose/Service and Repair.
-
Bleed the clutch system. Refer to => [ Clutch System, Bleeding ] See: Clutch Hydraulic System/Service and Repair/Procedures/02Q Transmission.
-
Install the crash brace, if equipped. Refer to => [ Crash Brace - Tightening Specification ] See: Pedal Assembly and Clutch Master Cylinder
Assembly Overview.
-
Install the left front footwell vent.
-
Install the driver side storage compartment.
-
Install the battery tray and the battery.
-
Install the air filter housing. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing