A3 L4-2.0L Turbo (BPY) (2006)
-
Open the clip - 2 - with a screwdriver and remove either the hose/line assembly - 1 - or the plastic hose from the clutch master cylinder.
-
Remove the Clutch Position Sensor (G476) from the clutch master cylinder - arrow - and disconnect the connector - 4 -.
-
Remove the driver side storage compartment.
-
Remove bolt - arrow A - and remove left front footwell vent - 1 -.
-
Unclip wiring guide behind footwell vent - 1 - and lay aside.
-
Remove the crash brace - 2 - (if equipped) - depending on the design, it is attached by one or two bolts - arrows B -.