A3 L4-2.0L Turbo (BPY) (2006)
/Page-3296003.png)
-
Lightly oil the outer circumference of the new seal.
-
Fill area between sealing lip and dust lip - arrow - halfway with Sealing Grease (G 052 128 A1).
-
Drive new seal in as far as the stop; be sure not to distort seal.
Secure and tighten the flange shaft and countersunk bolt - arrow -. Tightening specification => [ (Item 12) Countersunk Bolt - 33 Nm ] See:
Differential/Service and Repair/Removal and Replacement.
The rest of the installation follows the reverse order of removal, note the following: