A3 L4-2.0L Turbo (BPY) (2006)
Window Frame: Service and Repair
Rear Window Frame and Window Regulator
Window Frame And Window Regulator, Removing And Installing
1
-
Window frame
-
Removing:
-
Remove door trim.
-
Disconnect electrical harness connectors.
-
Remove window regulator motor
-
Remove bolts - 7 - and - 8 -.
-
Remove collared shoulder bolts - 3 - and bolts - 5 -; - 6 - and - 10 - and lift window frame with window regulator upward and out of door.
-
Installation:
-
Insert window frame and window regulator into door from above.
-
Knock in the upper profile halves of door-side gasket into window frame at top.
-
Position seals between door and window frame.
-
Loosely screw in collared shoulder bolts - 3 - at front and rear.
-
Then, loosely screw in bolts in the sequence - 5 - and - 8 -.
-
Tighten collared shoulder bolts - 4 - hand tight.
-
Tighten locating bolt - arrow b - to 32 Nm.
-
Lightly press window frame - 1 - inward at top.
-
Unscrew adjustment bushing on lower bolting points using an Allen wrench (width across flats 9 mm) turning toward left until it contacts
door plate.
-
Tighten bolts - 5 - at front and rear to 32 Nm.
-
Tighten collared shoulder bolts - 3 - to 32 Nm.
-
Tighten bolt - 8 - to 10 Nm.
-
Tighten locating bolt - arrow - in window frame to 32 Nm.
-
Knock in lower half of door seal into inner door plate.
-
Secure window regulator rail with bolts - 7 - to inner door plate.
-
Press threaded pin of window regulator reel through inner door plate until it engages.