A3 Mk1
| Servicing clutch release mechanism |
| 1 - | Gearbox |
| 2 - | Ball head stud, 25 Nm |
| q | Lubricate with MoS2 grease |
| 3 - | Input shaft oil seal |
| q | Renewing → Item |
| 4 - | Guide sleeve |
| q | With vulcanised O-ring for sealing at clutch housing |
| q | If O-ring is damaged, renew guide sleeve together with O-ring |
| q | Lubricate guide sleeve in area of release bearing with MoS2 grease |
| 5 - | Retaining spring |
| q | Secure to clutch release lever |
| 6 - | Socket head bolt, 20 Nm |
| q | Self-locking |
| q | Renew |
| 7 - | Clutch release lever |
| 8 - | Release bearing |
| q | Do not wash out bearing; wipe clean only |
| q | Renew bearings if noisy |
| q | Lubricate surfaces which contact release lever with MoS2 grease |
| 9 - | Flange bolt, 20 Nm |
| 10 - | Clutch slave cylinder |
| q | Removing and installing → Chapter |
| 11 - | Operating rod |
| q | Lubricate end of operating rod with MoS2 grease |
| 12 - | Assembly bolt |
| q | Secures clutch release lever while installing gearbox |
| q | Unscrew after gearbox has been installed |
Note| If the assembly bolt is not available, an M 8 x 35 bolt can be used instead. |
