audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Exploded view - hydraulic system > < Removing and installing over-centre spring (RHD vehicles)

A3 Mk1

Removing and installing clutch pedal (LHD vehicles)
Removing and installing clutch pedal (LHD vehicles)
Special tools and workshop equipment required
   
t  Pliers -T10005-
Removing
–  If fitted, turn clutch pedal switch -F36- 45° anti-clockwise and pull out of mounting.
–  Remove over-centre spring → Chapter or → Chapter.
–  Separate clutch pedal from master cylinder → Anchor and push operating rod towards engine compartment as far as stop.
  W00-1063
–  Remove nut -A-.
–  Pull out bolt until clutch pedal can be removed.
Installing
Installation is carried out in reverse sequence; note the following:
  N30-0216
–  The retaining clip -A- must be fitted to the master cylinder operating rod -B-.
–  Press clutch pedal in -direction of arrow- until it engages. Ensure that it is properly locked.
–  Install over-centre spring → Chapter or → Chapter.
–  If fitted, insert clutch pedal switch -F36- in mounting hole and secure by turning 45° clockwise. Clutch pedal must be pressed down.
  V30-0419

Exploded view - hydraulic system > < Removing and installing over-centre spring (RHD vehicles)