Servicing clutch mechanism

Make

Audi

Model

A3 Mk1

Section

5-speed manual gearbox 02T › Clutch, control › Servicing clutch mechanism

Power transmissionServicing clutch mechanism

Servicing clutch mechanism

→ Chapter „Checking hydraulic clutch mechanism“

→ Chapter „Exploded view - pedal cluster“

→ Chapter „Removing and installing over-centre spring“

→ Chapter „Removing and installing clutch pedal“

→ Chapter „Exploded view - hydraulic system“

→ Chapter „Removing and installing clutch master cylinder“

→ Chapter „Removing and installing clutch slave cylinder“

→ Chapter „Bleeding clutch system“

  Note

t	Before renewing the clutch master cylinder or clutch slave cylinder on the assumption that it is defective you must first check the clutch mechanism → Chapter.

t	Disconnect battery earth strap.

t	Note radio coding for vehicles with coded radio.

t	Apply polycarbamide grease -G 052 142 A2- to all bearings and contact surfaces.

t	Make sure that no brake fluid escapes into the footwell, the plenum chamber or onto the gearbox below. If this does happen, clean the affected area thoroughly.

t	Before working on pedal cluster, remove driver's storage compartment → Rep. Gr.68.

I -	Exploded view - pedal cluster → Chapter

II -	Exploded view - hydraulics → Chapter

04 Transmission