A3 Mk1
| Removing and installing selector cables - exploded view |
Note| Lubricate all bearings and moving surfaces with polycarbamide grease -G 052 142 A2-. |
| 1 - | Gear selector cable |
| q | Press onto gear lever guide |
| q | Installation position → Chapter |
| 2 - | Gate selector cable |
| q | On gate selector lever |
| q | Installation position → Chapter |
| 3 - | Securing clip |
| 4 - | Securing clip |
| q | Take care not to damage selector cables when removing. |
| 5 - | Selector housing |
| 6 - | Cable support bracket |
| 7 - | Bolt |
| q | 25 Nm |
| q | With washer |
| q | For cable support bracket |
| 8 - | Grommet |
| q | Mounting for cable support bracket on gearbox |
| 9 - | Distance piece |
| 10 - | Cable end-piece |
| q | Secures gate selector cable → Item to gate relay lever → Item |
| q | Always renew if removed from gate relay lever |
| 11 - | Cable end-piece |
| q | Secures gear selector cable → Item to gearbox selector lever → Item |
| q | Always renew if removed from gearbox selector lever |
| 12 - | Gate relay lever |
| q | Installation position → Fig. |
| 13 - | Bearing bush |
| 14 - | Securing clip |
| 15 - | Slide block |
| 16 - | Gearbox selector lever |
| q | With damper weight |
| q | Install so that gap in splines aligns with selector shaft → Fig. |
| q | After installing, adjust selector mechanism → Chapter |
| q | Installation position → Fig. |
| 17 - | Nut |
| q | 20 Nm |
| q | Self-locking |
| q | Always renew |
|
|