Audi Workshop Service and Repair Manuals > A3 Mk1 > Power transmission | 5/6-speed manual gearbox 02M/02Y, four-wheel drive | Clutch, control | Servicing clutch mechanism | Removing and installing clutch pedal switch F36 (round housing)

Removing and installing clutch pedal switchF36 (round housing)

Removing and installing clutch pedal switch -F36- (round housing)

Note

Clutch pedal switch may only be fitted once so as to ensure a firm fit.

Removing

–	Remove storage compartment on driver's side → General body repairs, interior; Rep. Gr.68.

–	Unplug electrical connector from clutch pedal switch.

–	Remove clutch pedal switch by turning in anti-clockwise direction through 45°.

Installing

Installation is carried out in reverse sequence; note the following:

–	Pull out operating rod -arrow- all the way before installing clutch pedal switch.

l	The clutch pedal should be in the normal position (i.e. not pressed down).

–	Guide clutch pedal switch through mounting hole, press operating rod against clutch pedal and attach switch by turning 45° clockwise.

–	Install storage compartment on driver's side → General body repairs, interior; Rep. Gr.68.

Audi Workshop Service and Repair Manuals