Audi Workshop Service and Repair Manuals > A3 Mk1 > Power transmission | Automatic gearbox 09A | Automatic gearbox, gears, control | Removing and installing senders in gearbox | Removing and installing vehicle speed senderG68 and intermediate shaft speed senderG265

Removing and installing vehicle speed senderG68 and intermediate shaft speed senderG265

Removing and installing vehicle speed sender -G68- and intermediate shaft speed sender -G265-

Removing

–	Unbolt torque converter housing → Chapter.

–	Take out axial needle bearing -B- and differential -A-.

Note

-Items 1 and C- can be disregarded.

–	Unplug connector from sender.

-1-Vehicle speed sender -G68-

-2-Intermediate shaft speed sender -G265-

–	Unbolt sender -arrows- and remove.

Installing

–	Fit new sender and tighten bolts to 8 Nm.

Assembling gearbox → Chapter

Audi Workshop Service and Repair Manuals