audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Front brakes FN 3 > < Removing and installing brake pads - front brakes

A3 Mk2

Removing and installing brake caliper - front brakes
Removing and installing brake caliper - front brakes
Special tools and workshop equipment required
   
t  Brake pedal actuator -V.A.G 1869/2-
Removing
–  Remove brake pads → Chapter.
  W00-0679
–  Insert brake pedal actuator -V.A.G 1869/2- between brake pedal and driver's seat. Depress the brake pedal at least 60 mm.
  Note
This closes the valves in the brake master cylinder and stops the brake fluid reservoir from running empty.
–  Connect hose of bleeder bottle to bleeder screw of removed brake caliper.
–  Open bleeder screw.
–  Do not remove brake pedal actuator -V.A.G 1869/2-.
–  Unscrew brake hose from brake caliper.
Installing
Installation is performed in reverse sequence; note the following:
–  Install brake pads → Chapter.
–  Bleed brake system: ABS/ESP Mark 60/ ABS Mark 70 → Chapter.
Tightening torque
  A44-0020
Component Nm
Brake hose to brake caliper35

   

Front brakes FN 3 > < Removing and installing brake pads - front brakes