A3 Mk2
| Table of adjustments |
Note| When performing repairs on the gearbox it is only necessary to re-adjust the input shaft, output shaft or differential if components have been renewed which have a direct effect on the adjustment of the gearbox. Refer to the following table to avoid unnecessary adjustment work: |
| Components requiring adjustment: | ||||
| Input shaft → Chapter | Output shaft → Chapter | Differential → Chapter | ||
| Components renewed: | Gearbox housing | x | x | |
| Clutch housing | x | x | x | |
| Input shaft | x | |||
| Output shaft (final drive gear set) | x | |||
| Differential cage | x | |||
| Tapered roller bearings for input shaft | x | |||
| Tapered roller bearings for output shaft | x | |||
| Tapered roller bearings for differential | x | |||
| 4th gear wheel | x | |||