Audi Workshop Service and Repair Manuals

Removing and installing gear selector cable and gate selector cable Removing –  Remove selector mechanism → Chapter

–  Using a screwdriver, bend open tabs -arrows- for selector mechanism on floor plate and remove floor plate. –  Remove gasket.

–  Take off securing clips -1 ... 4- and detach gear selector cable and gate selector cable from selector housing.   Note t  Securing clips -1 and 4- on the selector mechanism are discontinued from model year 2008 onwards. t  Then press cables off gate selector lever and gear lever guide.

Release cable end-pieces -A- for gate selector cable and gear selector cable -B- as follows: –  Push locking sleeve forwards as far as stop -arrow 1-. –  Turn locking sleeve as far as it will go in direction of arrow -2- so that it engages. –  Detach cable end-pieces from cables.

–  Pull off securing clips -1- and -2-. –  Detach cable support bracket from cables.

Installing Installation is carried out in reverse sequence; note the following: –  Secure gear selector cable and gate selector cable to selector housing with securing clips -1 … 4-.   Note t  Securing clips -1 and 4- on the selector mechanism are discontinued from model year 2008 onwards. t  Then press cables onto gate selector lever and gear lever guide.

–  Fit gasket and secure floor plate to selector mechanism by bending over tabs -arrows-. –  Install selector mechanism → Anchor. –  Adjust selector mechanism → Chapter.